ultracopier for linux debian not showing up

#Ultracopier for linux debian not showing up install
#Ultracopier for linux debian not showing up serial

AppArmor: AppArmor disabled by boot time parameter Calibrating delay loop (skipped), value calculated using timer frequency. CPU 0 irqstacks, hard=eec06000 soft=eec08000 RCU dyntick-idle grace-period acceleration is enabled. Checking if this processor honours the WP bit even in supervisor mode.Ok. Inode-cache hash table entries: 65536 (order: 6, 262144 bytes) Dentry cache hash table entries: 131072 (order: 7, 524288 bytes) PID hash table entries: 4096 (order: 2, 16384 bytes) Kernel command line: BOOT_IMAGE=/vmlinuz-3.2.0-4-686-pae root=/dev/mapper/brewster-root ro quiet Built 1 zonelists in Zone order, mobility grouping on. setup_percpu: NR_CPUS:32 nr_cpumask_bits:32 nr_cpu_ids:1 nr_node_ids:1 Booting paravirtualized kernel on bare hardware Local APIC disabled by BIOS - you can enable it with 'lapic'

Normal zone: 188706 pages, LIFO batch:31 free_area_init_node: node 0, pgdat c1412800, node_mem_map ef0ff200 kernel direct mapping tables up to 2f6f0000 19f9000-1a00000

Base memory trampoline at 9b000 size 16384 Notice: NX (Execute Disable) protection missing in CPU! It's headless, but I assume you at least have SSH access for the above.Ĭode: Select all Initializing cgroup subsys cpuset Try to manually look through dmesg|less after booting to see if there is a reason given for not loading those devices during boot.

#Ultracopier for linux debian not showing up install

Which command are you using to ennumerate your devices?Ĭheck the output of 'dmesg|tail' after you plug in the devices, please post the result here.ĭid you install anything special to get Debian to recognise your Nano V3's? Maybe there is some documentation with that.

I would venture to say that your USB devices require something that gets loaded after USB devices are initialized. USB devices not being identified/loaded on boot is generally not expected behaviour. You will probably get a different result using Jessie (it systemd for init)

#Ultracopier for linux debian not showing up serial

I'm assuming these are FTDI USB to Serial devices. You left out some important information in your post that most Debian users probably do not know.